Raspberry Pi Model A+ Review

Test Results

In the table below, all results are in milli-Amps (mA)

Model Max Boot Idle Post Halt
A+ 152 96 25
A 214 137 35
B+ 241 197 52
B 414 328 109

The Raspberry Pi Model A+ has the best (lowest) power consumption of all four models tested!

I am still somewhat troubled about the post-halt current consumption, as 25mA adds up over time.

Raspberry Pi Model A+ Review @ https://Mikronauts.com

The bar chart makes the difference in power consumption quite obvious.

(click on the image for a larger version)

I plotted the logged power consumption for the tests, and created an overlapping chart of the results.

As I am merely human, I could not align the phases (boot, log in, sudo halt, halted) perfectly, and I moved some of the of the data so that it would line up fairly well. The power savings of the Raspberry Pi Model A+ are very evident here.

Conclusion

The new Raspberry Pi Model A+ is a great addition to the Raspberry Pi Foundation’s line-up of low cost educational single board computers.

The low power consumption – and extremely low cost – makes it ideal for a lot of embedded applications.

It can also be an excellent educational computer when equipped with a powered USB hub – but frankly, the Model B+ with twice the ram and four USB ports is a much better choice as a non-embedded educational computer.

Raspberry Pi Model A+ Review   @ https://Mikronauts.com

(click on the image for larger version)

What I liked about the new Raspberry Pi Model A+

  • better power supply
  • VERY low power consumption
  • 5 more available I/O than Model A (as rev.2 had four I/O’s on P5)
  • micro SD
  • four mounting holes
  • smaller form factor
  • 99% software compatibility (1% off for no P5 I/O’s)
  • good hardware compatibility
  • LOWER PRICE

What I did not like about the Raspberry Pi Model A+

  • the full schematic is not available
  • amount of current used when the Pi is “turned off” is still more than I like
  • loss of GPIO formerly on P5

Not releasing full schematics is an issue for advanced users, especially as the Raspberry Pi Model A+ is so suitable for embedding into devices and will likely be used for IoT often. There is no valid reason for not releasing the schematics – the Broadcomm chip can only be purchased in vast volumes (as witnessed by the death of the Odroid-W), and any “clones” using a different processor are not really clones as they cannot run all Pi software. I am hoping that the Raspberry Pi Foundation will release the full schematics soon.

As a highly technical user, I am looking forward to embedding the Model A+ for all sorts of interesting applications!

If I had to give the Raspberry Pi Model A+ a numeric rating, I’d rate the new Rasberry Pi Model A+ at 95% – a $25 512MB version would have scored 99%

VERY Well done!

Related Links

 

Article Index

  1. Introducing the Raspberry Pi Model A+
  2. 40 pin GPIO header, Only ONE USB Port
  3. Switching Power Regulation, Improved Board Layout, Software Compatibility, Hardware Compatibility
  4. Hardware Compatibility (continued)
  5. USB WiFi stick compatibility, Power Consumption
  6. Power Test Results, Conclusion

Pages: 1 2 3 4 5 6

If you liked this article, please help us grow! "Like" us and let your friends know with the Twitter and Facebook buttons at the top left - We appreciate your support!